Description:
17-Series 14-inch Color Monitors
Details:
Ikegami 17 Series are High performance, Low cost color Monitors, providing NTSC-PAL automatic selection. The units are specifically designed for production or broadcast applications and provide high-fidelity video reproduction with easy operation, utilizing In-Line Gun CRT technology, BFS circuits, and Comb filter (NTSC only).
The 17 Series Color Monitors can accept 2 composite video, Y/C, and RGB or Component inputs in both NTSC and PAL formats. Furthermore, Digital Inputs (D1, D2, D3 formats) are available with optional modules.
Features:
Cathode Ray Tube
In-line Self Converging Electron Gun assures convergence stability. Black Mattix surrounding CRT face assures high contrast under bright ambient lighting. Circuitry
NTSC-PAL mode selection Screen aspect ratio of 4:3 or 16:9, with front panel switchable. BFS (Beam Feed-Back System) provides long-term Black Level stability. Pre-set Controls: Hue (NTSC Only), Chroma, Y/PB/PR Chroma, Brightness, Contrast Comb Filter provides wide band luminance, switchable to notch filter at front panel (NTSC only). Sweep failure protection circuit prevents phosphor bums. System Conveniences
4 Video Inputs (A/B/YC/RGB or Y, PB, PR), with front panel switchable. Digital Inputs (DI or D2 and D3 formats) are available with optional modules. Horizontal Time Constant can be selected in either 0.5msec. or 2msec. 13V and 19V Rack mount units available. Test Facilities
Underscan switch to permit observation of picture corners. Pulsecross switch for sync signal verification.
Specifications:
GENERAL Input Voltage 100V-120VAC ± 10%, 50/60Hz, Single Phase
200V-240VAC ± 10%, 50/60Hz, Single Phase
(switchable from the internal connector) Power Consumption Approx. 60W Ambient Temperature 0-40°C (32- 104°F), 90% or less relative humidity
(non-condensing) Dimensions (WHD) TM14-17RZ/RPZ: 450 X 265 X 515mm (17.7 X 10.4 x 20.3in) Weight TM14-17RZ/RPZ: Approx.19kg (41.9 lbs.) RATING Input Signal Video: 2 inputs
Y/C: 1 input
RGB/Y, Pb, Pr: 1 input * Switchable at Rear Panel
Digital Video: 2 inputs (Option)
Sync: 1 input
Input Level Video Signal:
Composite 1.0 Vp-p
Non Composite 0.7 Vp-p
Y/C signal:
Y signal 1.0Vp-p
C signal 0.286Vp-p (burst level)
RGB or Y, Pb, Pr:
(RGB Signal)
G signal 1.0Vp-p (Sync on Green) or 0.7Vp-p
R/B signal 0.7Vp-p
(Y, Pb, Pr signal) N10/SMPTE Format
Y White: 0.7Vp-p
Setup: 0%
Sync: 0.3Vp-p
Pb, Pr: 0.525Vp-p
Digital Video (D1, D2, D3):
Serial: 0.8Vp-p ± 10%
Sync Signal: Composite Sync 4Vp-p ± 2Vp-p
Connection Video/RGB or Y, Pb, Pr:
Bridging BNC connectors, high impedance with 75ohm termination plug
Y/C:
4pin plastic connector, single end. 75ohm terminated
(7pin metal connectors are OPTION) Remote Controls Parallel Remote:
Video input select (A/B/YC/RGB or Y, Pb, Pr/Digital) COLOR/MONO select Tally (ON/OFF) 4:3/16:9 (Parallel Remote:Unusable except for Tally, in case of Serial Remote operation.)Serial Remote (Option):
Video input select (A/B/YC/RGB or Y, Pb, Pr/Digital) COLOR/MOMO select Sync INT/EXT Blue only ON/OFF Comb/Trap Apt ON/OFF 4:3/16:9 Nor/Underscan Delay (PCR) ON/OFF Degauss ON/OFFPERFORMANCE CRT TM14-17RZ/RPZ:
In-line gun, Dot-shadow mask, high resolution CRT
EBU Phosper Mask Pitch TM14-17RZ/RPZ(13V): 0.28mm Resolution (at center) TM14-17RZ/RPZ (13V): 650TV lines or more VIDEO SIGNAL SYSTEM Frequency Response Measured with Aperture Gain 0, (notch filter OFF)
50Hz - 7MHz; flat with in +1/-3dB (referred to 100kHz) Pulse Response At each RGB amplifier output with 0.05 micro-sec.
rise time square wave video input
Overshoot 10% or less (at 250kHz)
Sag (Tilt): 5% or less (at 50 Hz) Chrominance Rejection Ratio Less than -24dB (with aperture correction 0, notch filter ON) Aperture Correction Waveform of Overshoot of 2T pulse appear symmetrically with notch filter ON Noise Coherent noise Less than -40dB
Other noise Less than -50dB COLOR SIGNAL SYSTEM Demodulation Axis R - Y, B - Y system Frequency Response NTSC: 3.58MHz ± 0.5MHz +1/-3dB
PAL: 4.43MHz ± 0.5MHz +1/-3dB
(measured at chroma output test point) Demoduration Axis Phase Error 90° ± 2° SYNC SYSTEM Sync Stability Stability of synchronization will be met for the following conditions
a) Internal Sync Video input level within ± 6dB
against the rated value of 1.0Vp-p b) External Sync Sync Signal Input leveI of 0.3-8.0Vp-p AFC Time Constants SLOW. Approx. 2.0msec.
FAST. Approx. 0.5msec. DEFLECTION SYSTEM Scanning Frequency Horizontal Nominal 15.734kHz (NTSC); 15.625kHz (PAL)
Vertical Nominal 59.94Hz (NTSC); 50 Hz (PAL) Scanning Amplitude NORMAL SCAN
(adjustable) Overscan is 1% of CRT effective area with an aspect ratio of 4.3 UNDER SCAN
(adjustable) Four comers are visible within boundary of effective area
with an aspect ratio of 4:3 or 16:9 Geometry and Linearlty Less than 2% of picture height Convergence Error Center Inside a drcle with diameter of 8O% of picture height Less than 0.5mm Corer Outside area of picture center; Less than 0.8mm HIGH VOLTAGE Tolerance 24kV ± 1kV Regulation ± 5% over the range of 0-450 microA referred to 150 microA OPTION SF-171 Serial remote and Y/C Input 7 pin connector
DK-173 D1 SDI Input Kit
DK-174N D2/D3 NTSC SDI Kit
TTM-20 Slides rail and A-TM14-20 Rack metal
SRC-301 Serial Remote Controller (BNC connector control)